GM Accelerator Rod Carburetor
Replacement LH accelerator rod clip with 3/16 dia hole. This clip holds the accelerator rod in place on the carburetor. Check your application and make sure you need a LH clip. If need a RH clip use part # 10716
1967-71 GM Brake & Clutch Pedal Pad
Correct reproduction of the brake pad use on all 1967-71 Camaro Firebird & 1968-72 Chevelle models equipped with manual transmissions and drum brakes. This pedal pad can be used for either the brake or clutch pedal.
1967-81 GM Accelerator Pedal Pad
Correct reproduction of the 1968-81 Camaro/Firebird, & 1968-72 Chevelle accelerator pedal pad. Includes the same ribbed design as the original. This pad mounts directly on the accelerator arm.
1967-81 GM Accelerator Pedal Pad Trim
Reproduction of the accelerator trim plate use on 1967-81 Camaro/Firebid & 1968-72 Chevelle models. This plate will install easily on all accelerator pads and includes small tabs for locking in place.
1968-75 GM Accelerator Control Cable Retainer
Plastic retainer used to hold the accelerator control cable. It slips over and clips into accelerator pedal arm.
1967-69 Camaro - 6 cylinder
1967 Camaro Throttle Rod Small Block
Accurate reproduction of original Camaro 327 & 350 throttle rod with Rochester 4 BBL carb. Includes a correct swivel. Correct gray phosphate plating. 12 3/8"
1968-69 Camaro Throttle Rod Small Block
Accurate reproduction of original Camaro 327 & 350 throttle rod with Rochester 4 BBL carb. Includes a correct swivel. Correct gray phosphate plating. 12 1/8"
1967-69 Camaro Throttle Rod Big Block
Reproduction of the of the 2 piece adjustable throttle rod for big block with Holley and aluminum high rise.