Door lock rod clip that attaches the inside door handle rod to the latch.

Fits:
1967-81 Camaro
1968-72 Chevelle
1967-81 Firebird

Replacement rear window track upper plate

Fits:
1968-69 Camaro
1968-69 Firebird

Aqua colored embossed GM door decal plate used on all 1967 Camaro models. Accurate reproduction and self adhesive back. Licensed GM Restoration Part.

Blue colored embossed GM door decal plate used on all 1968-70 models. Accurate reproduction and self adhesive back. Licensed GM Restoration Part.

Replacement bellcrank retainer used on various GM models. Two required to mount one bellcrank to door frame. Used on both RH or LH doors.
Fits:
1969-81 Camaro
1969-81 Firebird
1969-77 Chevelle
1967-77 Chevy II Nova

This clip is used to hold the door lock knob rod assembly to the lower rod assembly which pivots up and down when the door lock knob is raised or lowered. Clip used to hold the inner locking rod to the inner door frame panel. Sold in pair.

Fits:
1967-69 Camaro
1964-72 Chevelle
1967-69 Firebird

Correct reproduction of the original threaded nut that holds the window guides to door glass and quarter glass on most GM models from 1960 - 1981

Fits:
1967-69 Camaro
1967-69 Firebird

These are the screws that secures the door vent window to the door frame. This screw is installs in the top of the door frame below the vent window on the inside of the door. There is a recessed hole for this screw. Includes 2 screws.
Fits:
1967 Camaro
1967 Firebird

Reproduction of the RH door handle push button button lock spring. Over time, this spring wears out making it difficult to lock, unlock, and open the vehicle door.
Fits:
1967-81 Camaro
1967-81 Firebird
1965-72 Impala
1967-72 Chevelle
1967-69 Corvair

Door lock rod clip, washers and screw set.

Fits:
1967-81 Camaro
1967-81 Firebird

Be sure to include these door latch screws when replacing or repairing your door latch. Original screws are sure to be rusted, and could break off when removing the old latch. Save yourself the headache with this 6-piece door latch screw set that does both door latches. Fits most GM vehicles through 1981.

Exact reproduction of the forward front window stop for all 1968-69 Camaro and Firebird models. One required per door, fits either LH or RH.

Window track upper plate. Will fit both RH and LH side.

Fits:
1968-69 Camaro
1968-69 Firebird

Correct reproduction of the inner door lock rod for all 1967 Camaro and Firebird models. These rods are used to unlock the door from the inside. This is the rod that your door lock knobs attach to.

Correct reproduction of the inner door lock rod for all 1968 Camaro and Firebird models. These rods are used to unlock the door from the inside. This is the rod that your door lock knobs attach to.

Correct reproduction of the 1967-69 Camaro and Firebird original front door window regulator roller. Sold individually and 2 required per door glass.

Rubber gaskets used to install door glass mounting plates to glass. Does one door glass.
Fits:
1968-69 Camaro
1968-69 Firebird

Correct reproduction of the inner door lock rods for all 1969 Camaro and Firebird models. These rods are used to unlock the door from the inside. This is the rod that your door lock knobs attach to. The 1969 door lock rod is designed with a bellcrank type actuator and requires special retainers to mount the bellcrank to the inner door panel. Retainers (W-067) are sold separately. Two retainers per door is required.

Reproduction forward and rear front window stop. One 2-Piece kit per door. Works on either LH or RH.

Fits:
1967 Camaro
1967 Firebird

Reproduction of the original striker. The door lock striker is installed on the door jamb for either the RH or LH door. 2 required per car.
Fits:
1967-81 Camaro
1967-81 Firebird
1964-72 Chevelle
1964 -72 El Camino

Correct replacement door latch rod assembly for all 1967 Camaro and Firebird models. The door latch rod assembly connects the door handle mechanism to the latch. Complete assembly includes plated rod, anti-rattle sleeve, center and end clip. Fits both LH or RH

Correct replacement door latch rod assembly for all 1968-69 Camaro and Firebird models. The door latch rod assembly connects the door handle mechanism to the latch. Complete assembly includes plated rod, anti-rattle sleeve, center and end clip. Fits both LH or RH

Reproduction door hinge detent roller set. These machined steel rollers and shouldered allen head bolts are used to replace worn out roller and pin assembles. Each kit contains 2 rollers and 2 bolts. Minor drilling and tapping required.This kit repair both hinges.

Fits:
1967 Camaro
1967 Firebird

Reproduction forward and rear front window stop. One 4-Piece kit per door. Works on either LH or RH.

Fits:
1967 Camaro
1967 Firebird

Excellent reproduction of the original interior door latch remote used in 1967 Camaro and Firebird models with deluxe interior. Fits RH only

The inner door sash channel that is usually damaged or missing. Two required per car RH or LH

Fits:
1968-69 Camaro
1968-69 Firebird

Reproduction door hinge pin and bushing kit to repair broken door hinges with these repair kits that include four proper (hardened) shoulder pivot pins, eight bronze bushings and two over sized bushings. This kit repairs all 4 hinges.

Fits:
1967-69 Camaro
1967-69 Firebird

This is the track the window regulator rollers ride in to raise and lower the front door glass. It attaches to door glass with stud assembly (SW-057) as original. Two required per car.

Fits: RH or LH 1968-69 Camaro & Firebird models