Original type replacement nylon nuts and screws for use on the front and rear license plate brackets. These nuts push into the bracket and allow the screws to be inserted into the nut.

This hardware kit mounts the front license plate bracket to the front lower valance. To install remove the hood latch support bolt at the bottom of the valance and install bracket with bolt provide in existing j-nut attached to valance panel.
Fits:
1969 Camaro

This hardware kit mounts the front license plate bracket to the front lower valance.
Fits:
1967 Camaro
1968 Camaro

Technically correct reproductions of rubber license plate bumpers. Contains 3 bumpers.
Fits:
1967-68 Camaro
1966-67 Chevelle

Reproductions of rubber rear license plate bracket. Contains 2 bumpers.
Fits:
1969 Camaro
68-72 Chevelle

Front license plate kit that includes the hardware to mount the bracket to the front lower valance. Also comes with the hardware and rubber bumper to mount a license plate to bracket. When installing remove the bolt at the bottom of the valance that secures the hood latch support to lower valance and install new bolt to secure license bracket and latch support to valance.
Fits:
1969 Camaro

Reproduction license plate bracket for 1967-68 Camaro models. This bracket mounts to the front valance and the license plate is mounted to it. License plate screws and insert nuts not included and are sold separately.

Reproduction license plate bracket for 1969 Camaro models. This bracket mounts to the front valance and the license plate is mounted to it. Manufactured in stamped steel to factory specifications for an authentic appearance. License plate screws and insert nuts not included and are sold separately.

1967-68 Camaro front license plate kit includes the license plate bracket and the hardware to mount the bracket to the front lower valance and the hardware to mount a license plate to bracket.
Fits:
1967 Camaro
1968 Camaro

1969 Camaro front license plate kit that includes the license plate bracket and the hardware to mount the bracket to the front lower valance. Also comes with the hardware and rubber bumper to mount a license plate to bracket. When installing remove the bolt at the bottom of the valance that secures the hood latch support to lower valance and install new bolt to secure license bracket and latch support to valance.
Fits:
1969 Camaro

Reproduction rear license plate bracket that mounts to the rear valance. License plate screws and insert nuts not included and are sold separately.
Fits:
1969 Camaro
1968-72 Chevelle