Rubber door and trunk lock gaskets.
Fits:
1967-81 Camaro
1967-81 Firebird

Door bumper 2 piece set.

Fits
1967-69 Camaro
1967-69 Firebird

Dash ash tray bumpers. Sold in pairs
Fits:
1967 Camaro
1968 Camaro
1969 Camaro
1967 Firebird
1968 Firebird
1969 Firebird

Die cut gasket to replace your dry cracked wiper motor gasket used on all 1967-69 Camaro models.

Die cut gasket to replace your dry cracked wiper motor gasket used on all 1970-81 Camaro models.

Rubber trunk bumpers 2 piece set.
Fits: Camaro and Firebirds 1967 to 1981.

Reproductions of the door and lock gaskets on all 1967-69 Camaro and Firebird models. Kit includes a complete set of outer door handle gaskets RH and LH doors and both door locks and trunk lock gaskets.

Reproduction of the big block heater core gasket for use on all 1967-69 Camaro models.

Reproduction rear rocker panel flap for all 1968-72 Camaro and Firebird models. Prevents road splash and debris from entering and blocking the rocker panel drain area. This flap mounts on the rear side of the inner rocker panel. Sold as a pair.

These are the plastic push pins used to secure the end of door and roof rail seals to the body of the car. Includes 10 piece.

Fits:
1967-81 Camaro
1968-81 Firebird
1968-72 Chevelle
968-72 El Camino

1969 Camaro RS headlight door rubber bumper stops. Includes 4 pieces.
Fits;
1969 Camaro RS

Replacement seals that install under the cowl vent panel on each end.

Fits:
1967-68 Camaro

Door bumper 4 piece set.

Fits
1967-69 Camaro
1967-69 Firebird

Reproduction of the tail light socket gaskets for use on all 1978-81 Camaro models. Includes 8 die cut gaskets which will replace all on both LH and RH side

Replace your firewall steering column seal with this quality reproduction. Fits all 1967-68 Camaro models.

Replace your firewall steering column seal with this quality reproduction. Fits all 1969 Camaro models.

Reproduction of the rubbing insert use to hold the quarter chrome on the quarter glass. FITMENT NOTE: Model years for Camaro and Chevelle part compatibility are different.

Fits:
1967-69 Camaro/Firebird
1968-72 Chevelle

Installation Tip: Use silicone to install weatherstripping in quarter glass moldings

Installation kit for installing weatherstrip.
Includes:
6 Peel and stick felt pieces
10 Outer felt screws - stainless
10 Inner felt staples
1 1/16 Drill Bit
Instruction sheet included

This reproduction of the original upper push rod boot for 1967-69 Camaro and Firebird models with manual transmission. It is molded using correct E.D.P.M. stock and is superior to the original. Molded in steel insert distributes mounting screw pressure. Fits small block and big block applications.

Reproduction of the original boot for 1967-69 Camaro and Firebird models that slides over the steering column at the base of the floor. Replacing your boot will help keep fluids from entering through the firewall area. This high quality reproduction is licensed as official GM Restoration parts.

Note: Installation requires removal of the steering column from the vehicle.

Reproduction roof rail weatherstrip blow-out clips for 1967-69 Camaro and Firebird coupe models. Manufactured to factory tension in spring steel with rubber dipped ends as original. These blow-out clips install at the front door window top outer corners and helps to secure the roof rail weatherstrip. Sold in set of 4. On 1967 Camaro & Firebird use only 2 blow out clips.

These splash apron are exact duplicates of the original factory installed splash shields. They are designed to prevent dirt, water or other debris from entering the underhood engine compartment through the space in the inner front fender skirt. Kit includes: 2 "A" frame to fenderwell dust flaps with cloth insert neoprene sheeting. Fits all 1970-81 Camaro models.

Best quality weatherstripping on the market giving you the correct profile, fit and are soft and pliable as original.

Fits:
1967-81 Camaro
1968-81 Firebird

Best quality weatherstripping on the market giving you the correct profile, fit and are soft and pliable as original. Fits all 1967-69 Camaro and Firebird models and installs on the cowl top vent grille and seals the area between the hood and cowl panel.

Correct reproduction of the original rubber stoppers for use with all 1967-68 standard Camaro models and on correct for all 1967 Camaro RS models. Complete 16 piece kit.

Correct reproduction of the original rubber stoppers for use with all 1968 Camaro RS models. Complete 22 piece kit.

Replace your old splash aprons with new reproductions and keep your engine compartment clean and free of water, salt and other road debris. Each set will install on both drivers and passengers side. Kits includes a full set of original type staples.

Fits:
1967-69 Camaro
1967-69 Firebird

Replace your old splash aprons with new reproductions and keep your engine compartment clean and free of water, salt and other road debris. Each set will install on both drivers and passengers side. Kits includes a full set of original type staples.

Fits:
1969 Camaro
1969 Firebird

Reproduction of the original floor pan plastic plugs for use with floor pans and trunk pans on all 1967-68 Camaro and Firebird models. This is a 12 piece kit.

Reproduction of the original outer door jamb vent grill used with all 1968-69 Camaro and Firebird models. Manufactured using rigid ABS materials. Installs on quarter panel door jamb area directly below the U-shape door jamb rubber. This reproduction will restore the original cosmetic look of the door jamb area. This is the full version of the original including the backing area with internal filter. Two required per car.

Color: Black.