Replacement screws to install door jambs vents.
Fits:
1967-81 Camaro
1967-81 Firebird
1970-72 Chevelle

Correct reproductions of the original quarter window roller guide washer used on all 1967-69 Camaro and Firebird models. Located on the bottom of the quarter window roller. Sold individually.

Original type replacement nylon nuts and screws for use on the front and rear license plate brackets. These nuts push into the bracket and allow the screws to be inserted into the nut.

Trunk latch 9-piece hardware kit to install trunk latch in the trunk.
Fits:
1967-81 Camaro
1968-72 Chevelle
1967-81 Firebird

These are the screws used to install the 2 front windshield glass stops, the 8 piece lower clips and the 2 outer clips on the lower windshield molding. Includes 12 screw.
Fits:
1967-69 Camaro
1967-69 Firebird
1969-74 Nova

Reproduction of the original floor pan plug for use with floor pans and truck pans. Fits:
1967-81 Camaro
1967-81 Firebird
1968-72 Chevelle
1962-72 Nova

10 piece stud repair kit. Use this kit to replace missing or damage molding clip studs.
Fits:
1967-81 Camaro/Firebird
1974-72 Chevelle
1962-79 Chevy II Nova

Rubber trunk bumpers 2 piece set.
Fits:
1967-81 Camaro
1967-81 Firebird
1968-72 Chevelle
1966-79 Chevy II Nova

Fender shim 10-piece kit.

Contains: (5) 1-3/4 x 1-1/4 x 1/8" thick
(5) 1-3/4 x 1-1/4 x 1/16" thick

Body shim 10-piece kit.

Contains: (5) 1-1/4 x 1-1/4 x 1/8" thick
(5) 1-1/4 x 1-1/4 x 1/16" thick

Replacement rear window track upper plate

Fits:
1968-69 Camaro
1968-69 Firebird

Reproductions of the 1967-81 GM trunk lid hinge bolts used on Camaro/Firebird/Chevelle models. Kit includes 4 pieces.

Blue colored embossed GM door decal plate used on all 1968-70 models. Accurate reproduction and self adhesive back. Licensed GM Restoration Part.

Correct reproduction of the spare tire anchor wing nut.
Fits:
1967-81 Camaro
1967-81 Firebird
1968-72 Chevelle
1966-79 Chevy II Nova

Factory correct 4 piece hardware kit to install the cowl vent panel
Fits:
1967-69 Camaro
1967-69 Firebird

This 6-piece screw set used to mount the headlight ring to the headlight bucket. Fits:
1967-75 Camaro
1967-75 Firebird
1968-72 Chevelle
1968-72 El Camino

This clip is used to hold the door lock knob rod assembly to the lower rod assembly which pivots up and down when the door lock knob is raised or lowered. Clip used to hold the inner locking rod to the inner door frame panel. Sold in pair.

Fits:
1967-69 Camaro
1964-72 Chevelle
1967-69 Firebird

Correct reproduction of the original threaded nut that holds the window guides to door glass and quarter glass on most GM models from 1960 - 1981

Fits:
1967-69 Camaro
1967-69 Firebird

These are the screws that secures the door vent window to the door frame. This screw is installs in the top of the door frame below the vent window on the inside of the door. There is a recessed hole for this screw. Includes 2 screws.
Fits:
1967 Camaro
1967 Firebird

Door lock rod clip, washers and screw set.

Fits:
1967-81 Camaro
1967-81 Firebird

Be sure to include these door latch screws when replacing or repairing your door latch. Original screws are sure to be rusted, and could break off when removing the old latch. Save yourself the headache with this 6-piece door latch screw set that does both door latches. Fits most GM vehicles through 1981.

Exact reproduction of the forward front window stop for all 1968-69 Camaro and Firebird models. One required per door, fits either LH or RH.

Reproduction rear rocker panel flap. Prevents road splash and debris from entering and blocking the rocker panel drain area. This flap mounts on the rear side of the inner rocker panel. Sold as a pair.
Fits:
1967-72 Camaro
1967-72 Firebird
1964-72 Chevelle

Window track upper plate. Will fit both RH and LH side.

Fits:
1968-69 Camaro
1968-69 Firebird

Correct reproduction of the spare tire anchor "J" hook.
Fits:
1967-81 Camaro
1967-81 Firebird
1968-72 Chevelle
1966-79 Chevy II Nova

Replacement seals that install under the cowl vent panel on each end.

Fits:
1967-68 Camaro

Reproduction of the quarter window lower center guide roller used on all 1967-69 Camaro and Firebird models. Guide roller is located on the bottom of the quarter window allowing window to lower and raise on track. This roller will help keep your quarter window moving evenly on the track and eliminate one side from rolling up or down unevenly. Sold individually.

This clip mounts to the inner door panel on all 1967-69 Camaro and Firebird models and keeps the door latch rod assembly from bending when operated.