1967-81 License Plate Hardware
Original type replacement nylon nuts and screws for use on the front and rear license plate brackets. These nuts push into the bracket and allow the screws to be inserted into the nut.
1967-81 Floor / Trunk Pan Plug
Reproduction of the original floor pan plug for use with floor pans and truck pans. Fits:
1970-81 GM Hood Rear Outer Bumper Stopper, each
Reproduction of the outer rear hood rubber stopper. These fit over the existing jack bolt at the rear corners of the hood to make the final adjustment of your hood to get it aligned.
Fender Shim 10-Piece Kit
Fender shim 10-piece kit.
Contains: (5) 1-3/4 x 1-1/4 x 1/8" thick
(5) 1-3/4 x 1-1/4 x 1/16" thick
Body Shim 10-Piece Kit
Body shim 10-piece kit.
Contains: (5) 1-1/4 x 1-1/4 x 1/8" thick
(5) 1-1/4 x 1-1/4 x 1/16" thick
1967-81 Camaro Door Latch Screw 6 Piece Set
Be sure to include these door latch screws when replacing or repairing your door latch. Original screws are sure to be rusted, and could break off when removing the old latch. Save yourself the headache with this 6-piece door latch screw set that does both door latches. Fits most GM vehicles through 1981.
1964-72 GM Rear Rocker Rubber Drain Flap
Reproduction rear rocker panel flap. Prevents road splash and debris from entering and blocking the rocker panel drain area. This flap mounts on the rear side of the inner rocker panel. Sold as a pair.
1967-81 Camaro Firebird Spare Tire Anchor Plate
Correct reproduction of the spare tire anchor plate that is welded to the trunk floor pan that sats as a clamp by holding the spare tire hold down rod in place after the nut is tightened.
1967-81 GM Dimmer Switch
The headlight dimmer switch is located on the drivers front floor and used to switch the headlights from low beam to high beam. Dimmer switch on 79-81 Firebirds are on the steering column.
1970-81 GM Door Glass Guide Stop Bumpers, Pair
Replacement door glass stop bumpers. A must when replacing door glass, often so brittle it can be removed but not re-installed. This hard plastic bumper is required for proper door glass alignment. Sold in pairs only.