Replacement screws to install door jambs vents.
Fits:
1967-81 Camaro
1967-81 Firebird
1970-72 Chevelle

Original type replacement nylon nuts and screws for use on the front and rear license plate brackets. These nuts push into the bracket and allow the screws to be inserted into the nut.

Trunk latch 9-piece hardware kit to install trunk latch in the trunk.
Fits:
1967-81 Camaro
1968-72 Chevelle
1967-81 Firebird

Rubber floor plug. 2" diameter and fits a 1-1/2" diameter hole.

Reproduction of the original floor pan plug for use with floor pans and truck pans. Fits:
1967-81 Camaro
1967-81 Firebird
1968-72 Chevelle

Hood side bumpers. Sold in pairs
Fits:
1967-69 Camaro
1968-72 Chevelle

10 piece stud repair kit. Use this kit to replace missing or damage molding clip studs.
Fits:
1967-81 Camaro/Firebird
1974-72 Chevelle

Reproductions of the 1967-81 GM trunk lid hinge bolts used on Camaro/Firebird/Chevelle models. Kit includes 4 pieces.

Technically correct reproductions of rubber license plate bumpers. Contains 3 bumpers.
Fits:
1967-68 Camaro
1966-67 Chevelle

Blue colored embossed GM door decal plate used on all 1968-70 models. Accurate reproduction and self adhesive back. Licensed GM Restoration Part.

Correct reproduction of the spare tire anchor wing nut.
Fits:
1967-1981 Camaro
1968-72 Chevelle

Reproductions of rubber rear license plate bracket. Contains 2 bumpers.
Fits:
1969 Camaro
68-72 Chevelle

Reproduction rear rocker panel flap for all 1968-72 Chevelle models. Prevents road splash and debris from entering and blocking the rocker panel drain area. This flap mounts on the rear side of the inner rocker panel. Sold as a pair.

This clip is used to hold the door lock knob rod assembly to the lower rod assembly which pivots up and down when the door lock knob is raised or lowered. Clip used to hold the inner locking rod to the inner door frame panel. Sold in pair.

Fits:
1967-69 Camaro
1964-72 Chevelle
1967-69 Firebird

Correct reproduction of the original threaded nut that holds the window guides to door glass and quarter glass on most GM models from 1960 - 1981

Fits:
1967-69 Camaro
1967-69 Firebird

Correct reproduction of the spare tire anchor "J" hook.
Fits:
1967-1981 Camaro
1968-72 Chevelle

Hood side bumpers. Includes 4 bumpers.
Fits:
1968-72

Correct mounting hardware for mounting the 1971-72 Chevelle Tail Lights. 6-Pieces.

The headlight dimmer switch is located on the drivers front floor and used to switch the headlights from low beam to high beam. Dimmer switch on 79-81 Firebirds are on the steering column.
Fits:
1967-81 Camaro
1967-78 Firebird
1964-72 Chevelle

Correct Bumper and screw assembly to adjust front of hood height. Includes 2 bumpers and 2 screws.
Fits:
1967-81 Camaro
1967-81 Firebird
1964-72 Chevelle
1964-72 El Camino

These shoulder bolts and bushings are used to install the flapper in a functioning cowl hood. Includes 2 correct shoulder bolts and 2 correct bushings.
Fits:
1970-72 Chevelle

Correct reproductions of the original quarter window lower guide roller assembly used on all 1967-69 Camaro/Firebird models, and 68-72 Chevelle 2-Door models. Located on the bottom of the quarter window, this roller will help keep your quarter window moving evenly on the track. Sold individually.

Replacement door glass stop bumpers. A must when replacing door glass, often so brittle it can be removed but not re-installed. This hard plastic bumper is required for proper door glass alignment. Sold in pairs only.

Fits:
1970-81 Camaro
1969-71 Chevelle
1970-81 Firebird

These are the proper screws to hold the Chevelle headlight mounting rings in place. 12-Pc. Each ring requires 3 screws.
Fits: 1964-70 Chevelle mounting rings

Proper bolt set for attaching the hood hinge springs.
Fits:
1968-72 Chevelle

Reproduction of the spare tire anchor "J" hook and wing nut.
Fits:
1967-1981 Camaro
1968-72 Chevelle

Correct mounting hardware for mounting the 1970 Chevelle Tail Lights. 8-Pieces.

Correct reproduction of the inner door lock rods for all 1969-72 Chevelle models. These rods are used to unlock the door from the inside. This is the rod that attaches to the door lock knob. The 1969 door lock rod is designed with a bellcrank type actuator and requires special retainers to mount the bellcrank to the inner door panel. NOTE: This is for a single RH or LH door. For both doors order 2 sets.

Fits: 1969-72 Chevelle 2-Door models only, both LH and RH doors

Replace your firewall steering column seal with this quality reproduction. Fits all 1968-72 Chevelle models.

Reproduction of the original outer door jamb vent grille. Installs on quarter panel door jamb area. This is the full version of the original including the backing area. Two required per car. Color: Black.
Fits:
1970-81 Camaro
1970-81 Firebird
1970-72 Chevelle