GM Clutch Push Rod retainer clip.

Fits:
1968-72 Chevelle
1967-81 Camaro
1967-81 Firebird

Clutch and shifter clip. Includes 3 clips.
Fits:
1967-81 Camaro
1967-81 Firebird
1968-72 Chevelle

Bellcrank pivot felt seals.

Fits:
1968-72 Chevelle

Correct reproduction of the brake and clutch pedal shaft bushing set used on all automatics and manual pedals.

Fits:
1968-72 Chevelle
1967-81 Camaro Firebird

Clips used on manual clutch linkage.
Fits:
1967-81 Camaro
1967-81 Firebird
1968-72 Chevelle

Reproduction clutch fork boot. For small block and big block applications.

Fits:
1968-72 Chevelle
1967-81 Camaro
1967-81 Firebird

Drive shaft straps mounts. Used to secure drive shaft u-joint to rear axle. Sold in pairs.
Fits:
1967-81 Camaro
1967-81 Firebird
1964-72 Chevelle
1962-72 Chevy II Nova

Hardened pin stud, lock washer, nut and shifter cable retaining clip. Used on TH-350 and TH-400 with cable shift.

Fits
1968-78 Camaro
1968-78 Corvette
1967-78 Firebird
1968-77 Chevelle
1969-74 Grand Prix
1968-69 Fullsize Chevrolet

Engine block clutch pivot ball.
Fits:
1967-83 Camaro
1964-77 Chevelle
1962-79 Chevy II Nova

Clutch big block lower push rod.

Fits:
1968-72 Chevelle all models
1967-69 Camaro Big Block models

Clutch pivot ball that mounts to the frame.
Fits:
1967-69 Camaro
1964-69 Chevelle
1962-69 Chevy II Nova
1967-69 Firebird

Replacement rubber clutch rod boot is made to original factory specifications.

Fits:
1968-72 Chevelle

Clutch pivot ball that mounts to the frame.
Fits:
1970-81 Camaro
1970-72 Chevelle
1970-75 Nova
1970-81 Firebird

Reproduction transmission gear selector used with all floor mounted factory TH-350 and TH-400 with automatic shifters.
Fits:
1968-69 Camaro
1968 Chevelle
1968 El Camino
1968 Full Size Chevy

Often missing in re-builds, the firewall clutch boot retainer provides a secure seal against the firewall. The ring fits around the clutch boot and anchors it directly to the firewall.

Fits:
1964-67 Chevelle

Often missing in re-builds, the firewall clutch boot retainer provides a secure seal against the firewall. The ring fits around the clutch boot and anchors it directly to the firewall.

Fits:
1968-72 Chevelle

Exact reproduction of original in stamped steel with black finish. Bracket bolts to frame. Part number stamped on bracket as original. Spring sold separately.

Fits:
All 1970-72 Chevelle models.

Transmission shift cable bracket for GM 400 Turbo Trans.
Fits:
1968-72 Chevelle
1968-69 Camaro
1970-72 Camaro

Clutch upper push rod.

Fits:
1968-72 Chevelle

Two piece black/chrome shifter ball with 5/16" threads. Fits all Muncie style shifters with 5/16" threads.
Fits:
1967-68 Camaro
1967 Firebird
1968-71 Nova
1968-71 Chevelle

Fits on left side of the transmission pan for 1968-72 GM cars with Turbomatic 350 and 400. Fits a variety of models such as:
1968-72 Camaro/Firebird
1968-72 Chevelle
1968-72 Nova

Clutch small block lower push rod.
Fits:
1967- 81 Camaro
1967-81 Firebird
1964-67 Chevelle
1968-72 Nova

For small or big block applications. Accurate reproduction bell crank includes installed grease zerk fitting, frame side pivot ball with nut and washer, and pivot seat assembly. This is a quality heat-treated product, ready for installation, no assembly required.

Fits 1968-72 Chevelle

Muncie 4-speed mounting bracket kit to install backup light switch on transmission.

These lines are exclusively for Turbomatic 400 transmissions with 8.5 inch spacing at the radiator. Transmission cooler lines are sold in pairs, and designed only for factory engine, transmission, and radiator combinations. If your system components are not OEM replacement or 100% stock, please call us at (706) 884-9100 to discuss suitable alternatives.

Fits:
1972 Chevelle T400

These lines are exclusively for Powerglide transmissions. Transmission cooler lines are sold in pairs, and designed only for factory engine, transmission, and radiator combinations. If your system components are not OEM replacement or 100% stock, please call us at (706) 884-9100 to discuss suitable alternatives.

Fits:
1968-72 Chevelle with Powerglide Transmission

These lines are exclusively for Turbo 350 transmissions. Transmission cooler lines are sold in pairs, and designed only for factory engine, transmission, and radiator combinations. If your system components are not OEM replacement or 100% stock, please call us at (706) 884-9100 to discuss suitable alternatives.

Fits:
1968-72 Chevelle with Turbo 350 Transmission

These lines are exclusively for Turbo 400 transmissions. Transmission cooler lines are sold in pairs, and designed only for factory engine, transmission, and radiator combinations. If your system components are not OEM replacement or 100% stock, please call us at (706) 884-9100 to discuss suitable alternatives.

Fits:
1968-72 Chevelle with Turbo 400 Transmission

These lines are exclusively for Powerglide, and Turbomatic 350-400 transmissions. Transmission cooler lines are sold in pairs, and designed only for factory engine, transmission, and radiator combinations. If your system components are not OEM replacement or 100% stock, please call us at (706) 884-9100 to discuss suitable alternatives.

Fits:
1966-67 Chevelle with Powerglide, T350-400 Transmission

These lines are exclusively for 6-cylinder engines with Turbomatic 350 transmissions. Transmission cooler lines are sold in pairs, and designed only for factory engine, transmission, and radiator combinations. If your system components are not OEM replacement or 100% stock, please call us at (706) 884-9100 to discuss suitable alternatives.

Fits:
1970-72 Chevelle 6-cylinder with T350