Reproduction brake and clutch pin clip.
Fits:
1967-81 Camaro Firebird
1968-72 Chevelle
1962-79 Chevy II Nova

Drive shaft straps mounts. Used to secure drive shaft u-joint to rear axle. Sold in pairs.
Fits:
1967-81 Camaro
1967-81 Firebird
1964-72 Chevelle
1962-72 Chevy II Nova

Engine block clutch pivot ball.
Fits:
1967-83 Camaro
1964-77 Chevelle
1962-79 Chevy II Nova

Clutch pivot ball that mounts to the frame.
Fits:
1967-69 Camaro
1964-69 Chevelle
1962-69 Chevy II Nova
1967-69 Firebird

Swivel pin stud, (2) washer, (2) nuts, grommet and retainer. This swivel kit attaches to the end of your rod linkage at the shifter end and is used for adjustment.

Clutch Z-bar frame bracket
Fits:
1968-69 Camaro
1968-69 Firebird
1968-74 Nova
1971-74 Ventura
1974 GTO

Clutch pivot ball that mounts to the frame.
Fits:
1970-81 Camaro
1970-72 Chevelle
1970-75 Nova
1970-81 Firebird

Replacement rubber clutch rod boot.
Fits:
1970-81 Camaro
1970-81 Firebird
1975-79 Nova

Fits on left side of the transmission pan for 1968-72 GM cars with Turbomatic 350 and 400. Fits a variety of models such as:
1968-72 Camaro/Firebird
1968-72 Chevelle
1968-72 Nova

Clutch small block lower push rod.
Fits:
1967- 81 Camaro
1967-81 Firebird
1964-67 Chevelle
1968-72 Nova

1964-75 GM clutch housing/flywheel cover is for use on high performance Big Blocks and Small Blocks with heavy-duty clutches and 11 inch bellhousings. Hole measures 2 7/8" diameter. NOTE: NOT FOR USE ON GM TRUCKS!

Muncie 4-speed mounting bracket kit to install backup light switch on transmission.

Correct reproduction of the 4-Speed Neutral Safety Switch that mounts to clutch pedal under. Includes correct wire connector, rod with plastic bushing and (2) clips
Fits:
1969-70 Camaro
1969-70 Nova

Clutch big block complete linkage kit.

Kit includes:
1 Upper push rod
1 Upper rod boot
3 Rod clips
1 Frame side bracket
1 Block side stud with seal
1 Frame side ball stud with nut and washer
2 Bellcrank felts (only one required)
1 Lower adjustable rod
1 Return spring
1 Spring extension plate
1 Clutch fork to bellhousing rubber boot 1 BB Bellcrank assembly with installed pivot kit and zerk fitting.
Fits:
1967-69 Camaro
1968-72 Chevy II Nova